Archive for the Photography Category

Using the MLD Solo Inner Net as a mesh shelter @10 oz

Posted in backpacking, Captain's Personal Log, Photography, Reviews, Travel, ultralight techniques with tags , on December 11, 2017 by William Hooks
Solo Sil Inner Net (1)

Elastic pullout to stake

Solo Sil Inner Net (2)

modified pullout

Solo Sil Inner Net (3)

Solo Sil Inner Net (4)

2 poles used to erect shelter

Solo Sil Inner Net (5)

detail of UL cords securing pole tips

Solo Sil Inner Net (6)

side view of shelter-set poles @ 120 cm or longer

Solo Sil Inner Net (7)

detail of shock cord to pole handle

Solo Sil Inner Net (8)

enter via zipper at right

Advertisements

MLD Solo Silnylon Inner Net for Duomid shelter

Posted in backpacking, Captain's Personal Log, mountaineering, Photography, Reviews, Travel, ultralight techniques on December 5, 2017 by William Hooks

Continue reading

Mountain Laurel Designs Cuben Duomid shelter

Posted in backpacking, Captain's Personal Log, mountaineering, Photography, Reviews, ultralight techniques with tags , on November 10, 2017 by William Hooks

P6770026

P6770028

2 black button-type snaps on the front panel allow closure from inside, releasing tension on the zipper. A third snap is located at the foot of the same panel

P6770031P6770029

P6770019

This shelter height is achieved using a total pole length of c 145 cm, including pole jack

P6770018

4 corner anchors using MSR Carbon Core stakes

P6770017

Detail of mid-corner guylines attached to bungee cords

P6770016both doors openone door open

P6770015

If needed, the attachment clips shown on the interior of the shelter can support a biv sack netting away from the user’s face- as well as use for inner mesh net

vent closeup 2

Large peak vent- from inside, the upper larger wand or strut can be removed to allow closure in storms

front view

The apparent translucency of the cuben material changes with exterior light intensity and direction

half side view

peak view from interior

next to the top of the trek pole is the black, small plastic clip which allows hanging of the inner mesh net- I connect this to microcarabiners to prevent damage to the clip

10 cm pole jack

6 in =10cm pole jack attached to trek pole tip

The Duomid ($440) arrived 5 weeks and 3 days after ordering online from MLD.com, located in Roanoke, VA. The shelter weight is 14 oz for 1-2 persons; I will be writing separately about the modular, Solo silnylon inner tent which hangs within this shell as needed for insect protection ($175).

The tarp was sent with a 10 cm= 6 in pole jack, which extends a standard trek pole if needed for a taut pitch. I find that to pitch near the ground, my 130 cm trek pole alone can work but the pitch is probably more wind-resistant using the extension. I use 12 stakes as standard. The shelter has 8 ground-level tieouts and 8 mid-tieouts, with a peak hang tieout=17 total.

With the option of hanging the tarp from its apex if desired, no pole or stick needed in appropriate locations.

There’s a great deal of  covered space – over 45 sq ft- a palace for one with a huge covered vestibule… I would be fine using for 2 so long as the conditions were not very wet, because one person would need to cross the other inside.  The peak vent is well designed including an integral stiffener, and can be completely closed if need arises.

Being made of Dyneema/cuben, this shelter is extremely light and does not absorb water, with almost no stretch after pitching.  I like that there is adequate privacy, but at the same time I can judge weather as it is translucent and do not need a dedicated window built in.

I will be treating the one front door zipper with care, including closing the base buckle before operating it to reduce stress. I opted to use Zip Care lubricant as well, available from MLD.

Super-ultralight backpacking: recent refinements

Posted in backpacking, Captain's Personal Log, mountaineering, Photography, Travel, ultralight techniques on May 26, 2017 by William Hooks

First, there’s my HMG square tarp setup which has evolved to modified pyramid mode as seen above. It requires a minimum of material in addition to the tarp itself- only 1 support such as a trek pole, up to 9 stakes (I use 6 titanium shepherd-crooks and 3 MSR Carbon Cores), 1-2 guylines.. the tarp fits into its original storage bag with total weight of 10 oz. If I include the second guyline it can bolster the first at the front of the shelter as seen, or be used to rig an A-frame setup for example. Here’s a shot of the setup from the side:

Modified pyramid tarp setup (1)

Next, there’s a DIY modification of the reservoir for the Sawyer Squeeze water filter to use as a gravity-fed system. I perforated the bottom with 2 x 1/4″ holes with a paper punch, attached a short black cord, and added a Tedco Tornado Tube from Hobby Lobby [don’t let it get out that I ever go there].  It connects where the sip top is seen at the upper aspect in this image. This system lets the water drain through the filter passively into whatever clean container you like which has a standard connection, such as a Propel or Smartwatter bottle.DIY Sawyer Grav-feed water_20L pad inflator

On the right, there’s a green 20L Sea to Summit silnylon sack which has been converted into an inflator for my Thermarest sleeping pads, by gluing a Thermarest AirTrap outlet at one corner; it has a piece of green tape on it in the upper left. That conduit connects directly to the open valve of the pad, fill the bag with air and compress into the mattress several times. No more blowing up pads by lung…..

I have also added a pair of Altra Lone Peak v3 running shoes and matching Darn Tough socks. The shoes weigh 25 oz per pair.

Altra Lone Peak v3 running shoes (1)Altra Lone Peak v3 running shoes (2)Altra Lone Peak v3 running shoes (4)Darn Tough socks_merino_Coolmax

The SUL pack I now use most of the time is from Gossamer Gear, the 2017 version of  the Murmur which weighs 8.5 oz and can be used with removable components- a hip belt w pockets, a rear foam sitpad which gives the pack structure, as shown –

Gossamer Gear Murmur 2017 model (1)Gossamer Gear Murmur 2017 model (2)

One of my favorite features of this pack is the addition of 2 keepers for trek poles. The limitations of this pack must be appreciated: it is not suited for loads > about 18 pounds, bush travel, off-trail desert travel or carrying dense loads such as camera gear or large water containers. If those and relatively bulky items usually associated with winter travel and longer trips with large food bags are not needed, I can get to a total pack weight of approx 11 pounds including food and water.

Full-coverage mode with 8.5 ft HMG square tarp

Posted in backpacking, Captain's Personal Log, mountaineering, Photography, Reviews, Travel, ultralight techniques on April 7, 2017 by William Hooks
  • Tetrahedral mode (1)Tetrahedral mode (2)Tetrahedral mode (3)Tetrahedral mode (4)Tetrahedral mode (5)Tetrahedral mode (6)

The Rode Newsshooter Kit and my project: THE FIGHT AGAINST TRUMPISAN (2017)

Posted in Audio, Captain's Personal Log, Photography, Photojournalism, Reviews, Video on February 15, 2017 by William Hooks

newsshooter_sennheiser-me-4n-lav-2newsshooter_sennheiser-me-4n-lav-1

p67601081p67601221p67601242p6760105p67601252p67601253I ‘ve been actively applying the wireless Rode Newsshooter Kit to supplement the 2 Filmmaker Kits I’ve had for some time, allowing excellent ENG sound production directly into my Panasonic GH4 4K mirrorless camera covering major events in California. The latest were 2 protest events in Los Angeles and San Francisco, against the incoming Trump regime. In Los Angeles, I had assistance with handheld mic interviews from one of my still shooters, Carmen Rosales and my old friend Mark Chambers did those honors at San Francisco International Airport, during the anti-Muslim ban event. Jim Garrett was the B-roll GH4 shooter in Los Angeles, and he has collaborated with me on editing and writing.

I was very impressed by the build quality and water resistance of the transmitter unit in driving rain at Los Angeles- I was concerned that the unit would fail at any time due to being soaked for hours, but it never missed a beat and the sound was remarkable when connected to my Sennheiser MD-46 dynamic microphone inside of a plastic bag.

It’s very convenient that the Newsshooter and Filmmaker receivers are identical, so that I can switch between them any time  simply by matching the channels with the corresponding transmitter or lav mic. There ‘s up to 40 v phantom power on the transmitter, more than enough to provide great gain for a Shure SM 58 or the Sennheiser dynamic mics; I can also use my Sennheiser ME-4 N lav mic with the transmitter and actively monitor its output using the headphone jack near the USB power jack. In addition, it can be powered by standard Sony FPS batteries as well as ubiquitous AA batteries.

Because it runs on wi-fi instead of RF, I have found it to be extremely reliable in field use even when surrounded by cell phones and other devices- and no need to manually match any frequencies. I can use up to 8 units at at time on individual channels.

My opinion: if you have $500 to spend on an XLR wireless system, this is by far the best option I have ever seen. Avoiding use of cables in an ENG environment has proven to be a significant advantage from the standpoint of safety, mobility, simplicity and reliability.

We’re going to be using the Newsshooter and Filmmaker Kits extensively, for continuing to document the rise of resistance to the Trump regime over the next several months.

The website and Facebook page for WATER HUNGRY documentary were posted today

Posted in Audio, Photography, Photojournalism, Travel, Video on October 1, 2015 by William Hooks
at the Hollywood anticorporate protest co-sponsored by ANSWER Coalition, Sept 2015

At the Hollywood anticorporate protest co-sponsored by ANSWER Coalition, Sept 2015

Commnal water dispensing station, East Porterville, CA

Communal water dispensing station, East Porterville, CA

Guy Fawkes lives on

Guy Fawkes lives on in protest

Melinda Steffen interviewing a resident dealing with acute water supply issues in East Porterville, CA

Melinda Steffen interviewing a resident dealing with acute water supply issues in East Porterville, CA

 

 

Patricia Magana and family, East Porterville, CA

Patricia Magana and family, East Porterville, CADSC00030

A version of the film's avatar; original artwork by Melinda Steffen

A version of the film’s avatar; original artwork by Melinda Steffen

Please check both our Facebook page and the film website for updates, reference links to information about the crisis over water in the state of California, and background about the process of creating this project.